Rape Reader - GE TermiNet 300 Operator's Manual

This bar n1CJVl'S the printing position one posi-
t
ion to the ri~_i,'11t withnut printing a character.
LINE FEED
(LF)
This
key
J.dvances the paper one print line if the
spac in~ lever is set for sin~)e spacing,,
or t\v(
i
printed lines if the spacing switch is set for double
spacing.
Codes
END OF TEXT (EOT)
This control code will tr an sf er the state
of
the
Tern1in~11 fron1 local or on-line to
standby.
I)ATA LINK ESCAPE (DLE-EOT)
ThesE:' two control codes, in sequence, will in-
itiate the disconnect sequence with the connected
data set, after which the
l-{eady
light will go off.
The Te rn1inal i!::l then auton1atically in the standby
n1ode.
!".SCA.PE J (MOTOR OFF)
These two control codes, when reco~·nized in the
proper sequence, turn the n1otor off.
ENQlTIRY (ENQ)
TlH' contrc)l coclt'
\Vht'll
rt.:"C'l'i
Vt'd
causes the an-
S\ve
rb~tck
nr tt.'r111inal identification to
be
trans-
n1itted if this option is included.
BELL (BEL)
Causes the ~tudible alarn1 to be sounded when
recog11izc'd.
ESC.:\ PE H (IVIOTOR ON)
These
t\vn cont:,ol
codes, when recognized
in
the
proper sequt'lH'C', turn the motor on topern1itprint-
1ng.
TAPE READER
General
'I'ilt'
pll()t(H'lt'C't1·ic Llpt'
r(·adc'r
will read and
t
r;111.~n1it
cL1Ll :1t tht· 10, 1
~' ~lncl
30 cps rate, depend-
Operator's Manual GEH-2184A
ing upon how the TERMINAL RATE SELECT switch
is set. The reader is capable of 120 cps operation.
The READ-OMIT switch will enable the reader
to READ or OM'IT the next character, word or line.
To backsp<Icc th(' tape one space. depress the back-
space key. Place the LOCK/NORMAL switch in
the LOCK position in order to provent the reader
from being turned on either remotely or locally.
Place the SK IP-DELETE switch in the "on" posi-
tion to skip tape deletes. To start a remote reader,
hold the control key and press the READER ON (Q)
key of the local terminal. To turn the reader off press
the
INTERRUPT button. To start a local reader,
push the RUN button.
Operation
1.
PL1ct'
tlie LOCK-NORM switch in the
~ORIV1
position.
2. Lift the shield over the photo-cell head and
insert 1-inch wide punched tape from right to left,
as shown in Figure. Close shield.
3. Put the SKIP-DELETE switch in the desired
position.
The reader n1ay now
be
operated fron1 a ren1ote
location or locally by
usin~
the reader control func-
tions.
Fig. 9. Tape reader
9