GE TermiNet 300 Operator's Manual page 32

MAKING CORRECTIONS
If you make an errorwhile writing
a"Block"
from
the
keyboard, or
find
an error
while reading a
"Block",
you can substitute
the
incorrect character with
the
correct character as follows:
1. -Back up one character at a time, by pressing the STOP and BLOCK REWIND
pushbuttons, until you back over the incorrect character.
2.
3.
4.
5.
6.
18
-If it is more convenient, print one character at a time,
by
pressing the
STOP and READ pushbuttons, until you print the incorrect character. If you
do this, proceed with Step
3.
Print the selected character
by
pressing the STOP and READ pushbuttons, to
verify you are on the character to be substituted.
Press the WRITE pushbutton. The WRITE pushbutton should light.
Back up tape by pressing the CTL and Z (SUB) keys on the TermiNet 300 Printer.
The TCA will back up the tape one (1) space to the beginning of the character
to be substituted.
Enter the correct character from the keyboard.
Press STOP pushbutton to take the TCA out of "Write" mode.