Canon imagePASS-P1 Service Manual page 55

Printing to the imagePASS
If the customer can print the imagePASS Test Page but cannot print a job from a computer on the network, you may have to
make a service call. However, first make sure that the site administrator has done the following:
• Checked all components of the network, including cables, connectors, terminators, network adapter boards, and network
drivers.
• Activated the network and used it to communicate with other printers.
• Confirmed that the applicable network settings in Setup (such as AppleTalk zone, IP address, subnet mask, and gateway
address) match the settings used in the network.
When you make a service call, check the imagePASS connector panel to make sure that the appropriate network connection is
in place. Print quality problems are difficult to trace. Before you try to troubleshoot print quality problems, print a Test Page to
make sure that the printer does not need servicing or adjusting. Also, make sure that the correct paper is being used in the printer.
NOTE:
EPS file generation is not completely standardized among applications. Some users may encounter problems while printing certain
EPS files.
If the printer does not print
The following table lists possible causes and solutions when the printer does not print.
Possible Cause
Is the power on?
Are the cables between the image-
PASS and the printer connected?
Is the specified paper loaded?
Can you print a Test Page from the
printer driver?
Is the enclosed fan present and func-
tioning?
Other printing problems
The following table lists other printing problems and what to do about them.
Possible Cause
An image is printed on the reverse
side of the paper.
Multiple pages are fed through the
printer at once.
Paper misfeeds occur frequently.
It takes too long to complete the print
job.
Table 1: Causes and solutions when printer does not print
Turn on the imagePASS using the power switch and the printer power switch.
Make sure that the printer interface cables are completely and correctly connected to the printer
and the imagePASS.
Load the specified paper in any of the input trays.
If you cannot print the Test Page, the printer may be out of order. You may need to service the
printer
Verify that the enclosed fan is present, oriented correctly, and functioning (see
agePASS functionality after service" on page
Table 2: Other printing problems
Reload the paper in the paper tray upside down.
Remove all the pages from the paper tray and fan them gently before reloading.
Check the paper size settings. Use the recommended paper. Avoid using curled, folded, wrinkled,
perforated, or glossy paper.
The data is so large or complex that it takes additional time to process. If the Data indicator is
blinking, data is being processed. Wait until it is finished.
Solution
34).
Solution
50
5. TROUBLESHOOTING
"Restoring im-