Troubleshooting - Zanussi ZRA33132WA User Manual

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The appliance is noisy.
The lamp does not work.
The compressor operates
continually.
Water flows inside the refrig-
erator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
There is too much condensed
water on the rear wall of the
refrigerator.
6
Possible cause
The appliance is not suppor-
ted properly.
The lamp is in stand-by mode.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The water outlet is clogged.
Food products prevent water
from flowing into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The food products tempera-
ture is too high.
Many food products were
stored at the same time.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Solution
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Open the door only when neces-
sary.
Make sure the door is closed
completely.