Related Manuals for Zanussi ZRA33132WA
Summary of Contents for Zanussi ZRA33132WA
- Page 1 User Manual GETTING STARTED? EASY. ZRA33103WA ZRA33103WV ZRA33132WA EN User Manual Refrigerator...
-
Page 2: Safety Information
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. -
Page 3: Safety Instructions
Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. •... -
Page 4: Control Panel
• Do not put electrical appliances (e.g. ice cream • Before maintenance, deactivate the appliance makers) in the appliance unless they are stated and disconnect the mains plug from the mains applicable by the manufacturer. socket. • Be careful not to cause damage to the •... -
Page 5: Daily Use
DAILY USE Position the food so that air can circulate freely WARNING! Refer to Safety chapters. around it. Keep the food on all shelves no closer than 20 mm from the rear wall and 15 mm from the door. STORING FOOD IN A FRIDGE COMPARTMENT Cover or wrap the food, particularly if it has a strong flavour. -
Page 6: Troubleshooting
TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause Solution The appliance is noisy. The appliance is not suppor- Check if the appliance stands ted properly. stable. The lamp does not work. The lamp is in stand-by mode. Close and open the door. -
Page 7: Replacing The Lamp
Problem Possible cause Solution Stored food was not wrap- Wrap food in suitable packaging ped. before storing it in the appliance. Door does not open easily. You attempted to re-open the Wait a few seconds between door immediately after clos- closing and re-opening of the ing. -
Page 8: Technical Data
2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp (E) is secure over the outer sheath. - Page 12 WWW.ZANUSSI.COM/SHOP...