Table of Contents
Advertisement
9.0 Operation
NOTE: The Air Filtration Unit is designed to remove
airborne, non-metallic dust particles; it is not
designed to take the place of a dust collection
system.
Larger particles are trapped by the Pre-Filter.
Smaller particles are stopped by the Canister Filter.
The clean air is then exhausted through the
impellers at the top of the machine.
IMPORTANT: Do not block the top of the Fan Head
or any portion of the perforated Steel Barrel.
Normal operation:
•
Place Power On/Off Switch to ON.
•
Press the On/Off Button.
•
Set the SPEED as desired or select AUTO.
•
If desired, set the TIMER to automatically turn
off at a later time.
•
At the end of the day or shift, or if leaving for an
extended period of time, press the On/Off
Button to stop the fan.
•
If leaving for a longer period of time, such as a
weekend or vacation, turn the Power On/Off
Switch to Off.
10.0 User Maintenance
Always disconnect power to
the machine before performing maintenance.
Failure to do this may result in serious personal
injury.
10.1 Changing the Filters
To reduce the risk of injury,
disconnect the air filtration system from the
power source (unplug) before servicing or
changing filters. Failure to comply may cause
serious injury!
There are two filters that need to be changed or
cleaned, the Pre-Filter and the Canister Filter.
Filter life will vary depending on the amount of usage
and the environment of your shop. Clogged filters
will reduce the amount of air circulation.
1. Unplug the machine's power cord from the
electrical outlet.
2. Place a foot on the Base, grasp the Circle
Handle, and turn Fan Head counterclockwise to
unlock (see Figure 10-1).
3. Lift the Fan Head straight up set it aside.
4. Lift the Pre-Filter/Canister Filter out of the Steel
Barrel (see Figure 10-2).
12
Figure 10-1
Figure 10-2
Advertisement
Table of Contents
