Figure 1. Installing The Intel ® Raid Controller Rs2Sg244 - Intel RS2SG244 User Manual

4. Connect the provided internal and/or external cables into the adapter using the 4-
port combined end. Make sure the controller and cables are properly attached.
— If using an external cable, plug the cable into the connector in the end bracket.
— If using an internal cable, plug the cable into connector at the inside edge of the
Note: To prevent throughput problems:
8
Figure 1. Installing the Intel
adapter.
Use the cables provided or use the shortest possible cable.
Do not use cables longer than one meter.
Decrease the maximum length by one foot if you are using a backplane.
Do not use cross-over cables.
Only connect to a SATA drive, SAS or SATA backplane, or an expander
device.
Route the cables carefully.
Check that the controller and cables are all properly attached.
®
RAID Controller RS2SG244
Intel® RAID Controller RS2SG244 Hardware User's Guide
AF003498