Craftsman 247.888701 Operator's Manual page 19

6. Refill with the recommended oil and check the oil level. See Recommended
Oil Usage chart. The engine's oil capacity is 37 oz.
-40º -20º
-30º -20º -10º 0º
DO NOT use nondetergent oil or 2-stroke engine oil. It could shorten the
engine's service life.
7. Reinstall the oil filler cap/dipstick securely.
Thoroughly wash your hands with soap and water as soon as possible after
handling used oil.
Checking Spark Plug
DO NOT check for spark with spark plug removed. DO NOT crank engine with
spark plug removed.
If the engine has been running, the muffler will be very hot. Be careful not
to touch the muffler.
NOTE: Check the spark plug once a season or every 25 hours of operation. Change
the spark plug once a season or every 100 hours. To ensure proper engine operation,
the spark plug must be properly gapped and free of deposits.
1. Remove the spark plug boot and use a spark plug wrench to remove the
plug. See Figure 22.
2. Visually inspect the spark plug. Discard the spark plug if there is apparent
wear, or if the insulator is cracked or chipped. Clean the spark plug with a
wire brush if it is to be reused.
NOTE: An F6RTC spark plug must be used for replacement. For Sears
purchase, visit a Sears Parts & Repair Center or call 1-888-331-4569. Ask for
replacement spark plug 951-10292.
3. Measure the plug gap with a feeler gauge. Correct as necessary by bending
side electrode. See Figure 23. The gap should be set to 0.020-0.030 inches
(0.60-0.80 mm).
4. Check that the spark plug washer is in good condition and thread the spark
plug in by hand to prevent cross-threading.
5. After the spark plug is seated, tighten with a spark plug wrench to compress
the washer.
NOTE: When installing a new spark plug, tighten 1⁄2-turn after the spark plug
seats to compress the washer. When reinstalling a used spark plug, tighten 1⁄8- to
1⁄4-turn after the spark plug seats to compress the washer.
SERVICE AND MAINTENANCE
Synthetic
0W-30
5W-30
0º 20º 40º
CAUTION
CAUTION
WARNING
WARNING
Oil Drain
Plug
Spark Plug
Spark Plug Boot
Electrode
0.020-0.030 in.
(0.60-0.80 mm)
19
Figure 21
Figure 22
Figure 23