Installation - Snom SIP Series User Manual

Installation

SIP Cordless 1-line Hotel Telephone -
HD351
SIP Cordless 1-line Wi-Fi Enabled Hotel
Telephone - HD351W
Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown below.
• NOTE: Power adapter is not required
for Power over Ethernet (PoE).
2. When the telephone base has been initially
installed, make sure the power adapter
is securely plugged into an outlet not
controlled by a wall switch, and the Ethernet
cable is plugged into the network wall jack.
• The battery is fully charged after 11
hours of continuous charging. For best
performance, keep the cordless handset
in the telephone base when not in use.
3. Press on the telephone base. Listen for a
dial tone, then press
Note
• The dial tone will not be played if the SIP
account used by this telephone cannot be
registered.
• The power adapter is sold separately.
• Use only the power adapter described in
"Technical specifications" on page 28.
CAUTIONS
Use only the supplied Ethernet cables. The
supplied Ethernet cables are not designed
for use in any other IT devices. Misusing them
on your other IT devices shall be prohibited.
To order a replacement, contact authorized
service personnel, your seller, or Snom.
Installation option - install base
stand for desktop
To mount the telephone base on the base
stand
1. Align the grooves of the base stand with the
telephone base.
2. Slide the base stand up to secure it.
To unmount the base stand
Simply slide the base stand down, and lift it
from the telephone base.
EN - 10
again to hang up.