3
Operation
3.1 Intended use
The appliance was designed to be used in houses,
and is not fit for industrial use.
3.2 Attaching/removing the
hose
1. To attach the hose (1) push the hose cap (8) in
the direction of arrow until it is aligned with the
housing.
• The tabs on the hose cap (8) must be seated
correctly.
2. To remove the hose (1) press on the tabs on the
hose cap (8) and pull it.
3.3 Attaching/removing the
telescopic tube
1. Attach the telescopic tube (12) to the handle.
Vacuum cleaner / User manual
2. Pull the tube from the handle (12) to remove it.
3.4 Attaching/removing the
parquet/carpet brush
You can install/ remove the telescopic tube (12)
from/to the parquet/carpet brush (10) or crevice
tool (9).
3.5 Adjusting the parquet/
carpet brush
Press the adjustment latch located on the parquet/
carpet brush (10) and;
• Use "
" position for hard surfaces and
parquet.
• Use "
" for carpets.
3.6 Operation
1. Plug the appliance after pulling the power plug
located at the back of the appliance.
2. Press on/off button (3) to switch on your
appliance.
7 / 28 EN