Supermicro AS-1115HS-TNR User Manual page 44

Installing a Drive
1. Position the drive above the carrier with the PCB side facing down and the connector
end toward the rear of the carrier.
2. Tilt the drive to insert it onto the two posts on the right inside of the carrier.
Post
3. Pull out the two spring locking clasps and allow the drive to sit fully in the carrier, then
close them to secure the drive.
4. Insert the drive carrier into its bay, keeping the release button on the right. When the
carrier reaches the rear of the bay, the release handle will retract.
5. Push the handle in until it clicks into its locked position
Chapter 3: Maintenance and Component Installation
Figure 3-5. Installing a Drive into a Carrier
44
Locking Clasps