Table of Contents
Advertisement
ADJUSTING
THRUST
BEARINGS,
BLADE
GUIDE SUPPORT,
AND BLADE GUIDES
See Figures 14- 16.
_
WARNING:
Never operate saw without blade guard
secured in place. To do so could result in possible
serious personal injury.
The upper and lower blade guides and thrust bearings
support the band saw blade during cutting operations.
The adjustment of the guides and bearings should be
checked whenever a different blade is installed.
To Adjust Thrust Bearings:
The thrust bearings support the back edge of the blade
during cutting. The blade should not contact the thrust
bearings when you stop cutting. Htis important that both
upper and lower thrust bearings be adjusted equally.
NOTE: The thrust bearing screw is the upper cap screw
located on the right side of the blade guide assembly. Htis
the lower cap screw on the right side of the saw housing
below the saw table for the lower bearing.
[] Remove the blade guard by loosening the two set
screws with the 4 mm hex key.
[] Turn the lock lever counterc!ockwise
to unlock the
blade guide assembly. Turning the blade guide knob
(c!ockwise raises the blade guide assembly, counter-
clockwise
lowers it), position the blade guide assembly
about halfway between the saw table and saw housing.
Retighten the lock lever.
BLADE
GUIDE
ASSEMBLY
THRUST
BEARING
BLADE GUIDE
SUPPORT SCREW
Fig. 14
[]
[]
[]
Adjust the thrust bearings first. Using the 4 mm hex
key, loosen the thrust bearing screw.
Move the thrust bearing to within 1/64 in. of the blade.
Tighten the thrust bearing screw securely. Repeat this
procedure on the lower thrust bearing located below
the saw table.
Replace the blade guard if no additional adjustments
are to be made.
To Adjust
BmadeGuide Support:
[] Remove the blade guard by loosening the two set
screws with the 4 mm hex key.
[] Adjust the position of the blade guide assembly.
Loosen the bottom screw on the right side of the blade
guide assembly using the 4 mm hex key.
[] Slide the upper blade guide support on the shaft unti!
the front edge of the blade guides are about 1/64 in.
behind the gullet of the blade. Tighten the screw se-
curely. Repeat this procedure for the lower blade guide
support.
[] Replace the blade guard if no additional adjustments
are to be made.
NOTE: The lower blade guide support screw is the top
screw located on the right of the saw housing under
the table.
BLADE GUIDE
SUPPORT SCREW
B_LADE GUIDE
LOWER BLADE
GUIDE SUPPORT
THRUSTBEARING
BLADE GUARD REMOVED
FOR CLARIFICATION ONLY
Fig. 15
17
Advertisement
Table of Contents
