Playing Back A Tape - JVC CA-UXA52R Instructions Manual

Hide thumbs Also See for CA-UXA52R:
Table of Contents

Advertisement

Playing Back a Tape

You can play back type I, II, and IV tapes.
1
Press TAPE open/close 0 on the unit.
The unit automatically turns on, the electronic swing
panel slides downward, and the cassette loading slot
appears.
If a cassette is already in the cassette loading slot, it is
ejected.
2
Insert a cassette with the exposed part facing left.
The cassette is pulled in, then the electronic swing
panel slides upward automatically.
3
Press TAPE 2 3.
The tape starts playing.
• Each time you press the button, the tape direction
changes as follows:
:
Plays the front side.
:
Plays the reverse side.
Tape indicator
Tape direction
When the tape plays to the end, the cassette deck
automatically stops if the reverse mode is set to
. (See "To play both sides—Reverse Mode".)
To stop during play, press 7.
To fast-wind or rewind the tape, press ¢ or 4.
• When the tape direction is
• When the tape direction is
To eject the cassette, press TAPE open/close 0.
Cassette loading slot
• After ejecting the cassette, press TAPE open/close 0
To play both sides—Reverse Mode
You can set the cassette deck to play just one side of a tape,
both sides once, or both sides continuously.
• You can set this mode only when a cassette is already in
On the remote control ONLY:
Press REV. MODE.
• Each time you press the button, the reverse mode
To check the clock time while playing back a tape
On the remote control ONLY:
Press DISPLAY (not on number buttons.)
• Each time you press the button, the source information
Reverse mode
or
– 26 –
¢ : Fast-winds the tape.
4 : Rewinds the tape.
4 : Fast-winds the tape.
¢ : Rewinds the tape.
again to close the electronic swing panel.
DO NOT press TAPE open/close 0 during tape play.
the cassette deck.
changes as follows:
: To only play back one side (front or reverse.)
: To play back the front and reverse sides once.
: To play back both front and reverse sides
continuously.
and the clock time alternate on the display.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ux-a52rSp-uxa52

Table of Contents