Table of Contents
Advertisement
Hibernation Mode*
This option is only for hibernation models (CO & H2S). These models can be powered down (hibernated) to
suspend the operation and extend operational life. Hibernation models display 24 months upon activation
from new. This period remains in place until the ARA has exceeded 12 months of accumulated hibernation.
ION Science cannot guarantee the product after the warranty of 3 years.
To switch over to the hibernation mode, please follow the instructions below:
1) Position the ARA in front of the IR Link
2) Click on the hibernation button, the detector will then go into hibernation.
To differentiate the different models, the hibernation option models have two coloured lines on the label
whereas normal models have one thicker line. (See front cover for normal model image)
NOTES:
•
The event log will be cleared when the detector is hibernated. It is highly recommended to save event
logs before hibernation.
•
To re-activate the detector from hibernation status, press and hold the button for approximately 5
seconds.
•
When the detector is in hibernation, it is powered down, the screen will be blank and will not detect
any gases.
Using ARA Software
The below shows the user options which can be
Adjusted from a PC or Laptop
•
High Alarm
•
Low Alarm
•
Calibration Interval
•
Bump Interval
•
Self-Test interval
•
User ID
•
Display
Pioneering Gas Sensing Technology.
ARA Instrument User Manual V1.1
Page 19 of 27
ionscience.com
Advertisement
Table of Contents
