Husqvarna WS442HF Workshop Manual page 23

1
3
5
SERVICE AND MAINTENANCE SERVICE AND MAINTENANCE
2
4
Adjusting the guide wheels
In order for the saw to run stably
and make a straight cut, the
four guide wheels must rest
against the rail and not have too
much play�
Check the guide wheels during
service� When there is too
much play between the saw car-
riage and rail the guide wheels
must be adjusted:
1� Loosen the two hexagon socket
screws with an Allen key� Also
loosen the two stop screws which
locks the two exentiric guide
wheels with an Allen key�
2� Turn the shafts gently with an
Allen key until the guide wheels
rest agains the rail�
3� Hold the guide wheels in position
and tighten the two stop screws�
4� Press down the locking device
and pull the saw carriage in both
directions by hand� Carriage
should slide easily with a slightly
resistance� All 4 guide wheel
should spin�
5� Tighten screws with an Allen key�
Repeat the previous step�
7 7
23 23