Assemble The Track Feed Slip Clutch - Husqvarna WS442HF Workshop Manual

1
3
5
7
REPAIR INSTRUCTIONS
2
4
6
Assemble the Track Feed
Slip Clutch
First see: Disassemble the Track
Feed Slip Clutch (p. 113)
1� Clean everything firmly and glue
new friction washer with loctite
406� Keep it under pressure for
5h before assembly� A suggestion
is to have an already prepared slip
clutch ready, so that the WS can
continue to be assembled�
2� Fit the 2 new o-rings�
3� Fit the gearwheel�
Important that is no grease
between the friction washer and
gearwheel�
4� Lubricate and fit the 3 spring
washers� Note how these are to
be turned� The inner diameter
must be the highest point on all
washers. Then lubricate and fit the
flat washer to the gear wheel.
5� Fit and tighten the pressure plate
to a torque of 85–95 Nm (63–70
lbf·ft) using special tool nr: 521
12 31-23�
6� Retighten the 2 set screws�
Note! Check the slip torque�
Inspect the Track
See:
Feed Slip Clutch (p.
112)
7� Fit the o-ring�
10.3
1 1 5