Table of Contents
Advertisement
NLTroubleshooting
Malfunction
The program duration
changes during the wash
cycle.
The water is not
visible in the drum
bar.
Drum jerks after
program start.
Vibration and movement
of the appliance
during the spin
run.
Drum is spinning, er
no water flows into
the appliance.
strong foam
ming.
i-Doscannot be
pressed
48
Cause and Troubleshooting
No error - no action required.
▶
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The foam control system provides an extra rinse if the
foam is too high.
No error - no action required.
▶
The water is below visible range.
No error - no action required.
▶
▶ Do not fill the device with additional water during
operation.
The cause is an internal motor test.
No error - no action required.
▶
The appliance is not leveled properly.
→ †Adjusting the device", Page 17
▶
Device feet are not fixed.
Secure the device feet.
▶
→ †Adjusting the device", Page 17
Transport protections have not been removed.
→ †Remove transport locks", page 14 †
▶
Load recognition is active.
No error, no action necessary.
▶
Remark:The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric
▶
softener with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, reduce the
▶
basic dosing amount
→ Page 36 †
When dosing manually, reduce the amount of
▶
detergent for the next wash with an equal load.
Intelligent dosing is not possible for this program.
No error - no action required.
▶
→ †Start program with intelligent dosing system",
page 35
Advertisement
Table of Contents
