Malfunction
"E:36 / -10"
"E:38 / -25 / -26"
"E:10 / -00 / -10 /
- 20"
"E:60 / -2B"
Cause and Troubleshooting
When dosing manually, reduce the amount of
▶
detergent for the next wash with an equal load.
Unauthorized extension mounted on the water drain
hose.
Remove unauthorized extensions from the water
▶
drain hose.
→
†Connecting the device", page 16
Pump cover is not fully screwed in.
Make sure that the pump cover is screwed into the
▶
device as far as it will go. The pump cover handle
must be vertical.
Drain pump is clogged.
→ †Cleaning the drum", Page 37
▶
if the fault is displayed again,
→
†Cleaning the drain pump", page 39
▶
Inlet opening of the rubber sleeve is clogged.
→ †Clean the inlet opening in the rubber sleeve",
▶
page 41
Pump of the intelligent dosing system is blocked.
Turn off the device.
1.
Clean the pump unit.
2.
→ †Cleaning the detergent drawer", Page
37
If the indication reappears, enable the service.
3.
→
†Customer Service", page 55
Remark:You can start the washing program if you
deactivate the intelligent dosing system and dose
manually.
→ †Buttons", Page 25
The imbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Remark:If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
TroubleshootingNL
43