Craftsman 137.21229 Operator's Manual page 6

RECOMMENDED ACCESSORIES
IA WARNING I
Use only accessories recommended for this
miter saw. Foltow instructions that accompany
accessories. Use of improper accessories may
cause hazards.
, The usa of any cutting too! except 10 inch saw
blades which meet the requirements under
recommended accessories is prohibited. Do
not use accessories such as shaper cutters or
dado sets. Ferrous metal cutting and the use of
abrasive wheels is prohibited,
, Do not attempt to modify this toot or create
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious injury.
ACCESSORmES
Visit your Sears Hardware Department or see the
Sears Power and Hand Tool Catalog to purchase
recommended accessories for this power tool
I A WARNING I
To avoid the risk of personal injury, do not
modify this power tool or use accessories not
recommended by Sears.
IA WARNING I
Read warnings and conditions on your CARBIDE
TIPPED SAW BLADE. Do not operate the saw
without the proper saw blade guard in place.
Carbide is a very hard but brittle material Care
should be taken while mounting, using, and storing
carbide tipped blades to prevent accidental damage.
Slight shocks, such as striking the tip while
handling, can seriously damage the blade. Foreign
objects in the workpiece, such as wire or nails, can
also cause tips to crack or break off. Before using,
always visually examine the blade and tips for bent
blade, cracks, breakage, missing or loose tips, or
other damage. Do not use if damage is suspected.
Failure to heed safety instructions and warnings can
result in serious bodily injury.
.)
Blade Wrench (supplied)
Adjustable Wrench
Philips Screwdriver Hex Key 2_5 mm
Combination Square
COMBINATmON SQUARE MUST BE TRUE
Draw light line on board
along this edge.
Straight edge or
a 3/4 in. board,
this edge must be
perfectly straighL
\, /
L
!
Should not gap or overlap when
square is flipped over (see
dotted figure).