Craftsman 137.21229 Operator's Manual page 19

BEVEL CUT(FIG,S)
1_Whena bevel c utis required, loosen thebevel I ock
handle (1)_
2_Tiltthecuttinghead tothedesired angleasshown
onthebevel s cale(2).Thebladecanbepositioned
atanyangle, f roma 90° straight c ut(0° onthescale)
toa 45° leftbevel.
& Tighten thebevel l ockhandle (1)tolockthecutting
headin position_
Fig.S
CUTTING BOWED MATERIAL (FIG.U)
A bowed workpiece m ustbepositioned a gainst t he
fenceandsecured witha clamping device before
cutting. D onotposition workpiece i ncorrectly o r tryto
cuttheworkpiece w ithout t hesupport o fthefence. T his
wilIcause thebladetobindandcouldresult i n personal
injury.
Fig.U
2
1
COMPOUND C UT(FIG, T )
A compound c utisthecombination o fa miter anda
bevel c utsimultaneously.
1_Loosen thebevel l ockhandle (1)andposition the
cutting headatthedesired bevel p osition_ L ockthe
bevel l ockhandle.
2_ Loosen the miter tablelockhandle (2)_ Press down
thepositive stoplocking lever(3)andposition the
tableatthedesired angle. R elease thepositive stop
locking leverandlockthemiterhandle_
Fig.T
3
2
19