Table of Contents
Advertisement
Service Information (Blindfold Cap of Screw)
The FZ series use the blindfold caps of the screws on the rear cover for 360 degree viewing design.
To remove these caps from the rear cover, a flat-bladed screwdriver is necessary.
1. Number of use and Use position
Number of Blindfold cap : N=12
Number of Blindfold cap : N=10
65inch FZ series
55inch FZ series
2. Specification of a blindfold cap
Blindfold cap
8mm
Gap for removing (D-cut)
Notes when caps are assembled in the rear cover
1. Position of D-cut : Lower (Refer to above photo)
2. The surface of the cap must be flush with the rear cover.
3. How to remove the blindfold cap
a blindfold cap
Gap(D-cut)
a flat-bladed screwdriver
1. Prepare
a flat-bladed screwdriver
be inserted in the gap for removing
2. Insert this flat-bladed screwdriver in the gap(D-cut ).
3. Remove a blindfold cap
OLED
Blindfold cap
which can
86
Advertisement
Table of Contents
