Table of Contents
Advertisement
Refer to the separate installation instructions
booklet.
Water inlet and drain:
•
Strictly follow local Water Board regulations.
•
Make sure the inlet and drain hoses are kink-
free and are not crushed.
•
If the hose length does not suffice, replace
with similar hoses obtained from your local
dealer or our After-Sales Service.
•
The inlet hose must be securely clamped to
the water tap to prevent leaks.
•
The inlet water temperature varies according
to the model installed: inlet hose marked
"25°C max.": maximum temperature 25°C
All other models: maximum temperature 60°C.
•
When installing the appliance, make sure the
drain water discharges correctly and, if
necessary, remove the wire gauze from the
sink siphon.
•
Secure the drain hose with a clamp to the
siphon to prevent it from dropping off during
operation.
•
For appliances with water-stop system only:
if the water connections are made correctly,
the water-stop system safeguards your home
against damage caused by flooding.
18
CONNECTIONS
Electrical connections:
•
Closely adhere to local Electricity Board
regulations.
•
Voltage information is shown on the rating
plate mounted inside the door on the right
hand side.
•
The appliance must be earthed as prescribed
by law.
•
Do not use extension leads or multiple
adapters etc.
•
Before carrying out maintenance, disconnect
the mains plug.
•
Do not use the dishwasher if it has been
damaged in transit. Consult your local retailer
or our After-Sales Service.
•
The power cable must only be replaced by a
qualified technician.
Advertisement
Table of Contents
