How To Use The Dishwasher - Whirlpool ADG937 Manual

Open the door and turn on the water tap.
1. Press the I button (ON) to switch on the
appliance. One of the programme indicator
lamps will illuminate.
2. Press the programme selector button
until the corresponding indicator lamp
illuminates.
If required, select any additional functions .
3. Press the Start button to start the selected
wash programme. The Start indicator lamp
will illuminate. Once set, the programmed
data cannot be altered by pressing the
buttons or programme selector button. Close
the door.
Note: Once the Start button has been
pressed, the dishwasher memorises all the
programmes selected. The selected
programmes are also saved in the event of
power failure.
4. To change the programme selected, open
the door (beware of hot steam !) and press
the Start button for about 5 seconds until the
Start indicator lamp switches off. Select a
new programme using the programme
selector button, press the Start button, and
close the door.
5. At the end of the programme an acoustic
signal sounds 4 times and the Start indicator
lamp switches off.
6. Press the 0 button (OFF) to switch off the
dishwasher (only after the End indicator
lamp has switched on or the Start indicator
lamp has switched off.) All the indicator
lamps switch off.
Note: If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.

HOW TO USE THE DISHWASHER

1
2
3
4
5
6
17