Table of Contents
Advertisement
Quick Links
Quick reference guide
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
OPERATION
WASH TIME DISPLAY
INDICATOR
Indicated the cycle duration and the remaining time (h:min). With
A LED light projected
"Delayed start" selected it indicates the time remaining until program
on the floor indicates
start (h.00) - below 1h (0:min).
that the dishwasher is working.
If "Fx Ey" messages appears on the display, see page 9 - chapter
"What to do if...".
PROGRAMS
MULTIZONE
SELECTION
Allows you to choose the
washing zones. Press this
BUTTON
button (repeatedly) to
Push "Programs" button
select the wash zones:
(repeatedly) until the
indicator of the required
program lights up (see
"Table of programs" -
next page).
- indicator lits
POWER CLEAN
MAX
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
both racks
lower rack, in the specific
area. This option is
recommended for
washing pots and
only lower rack
casseroles (see page 7).
Press this button to
only upper rack
activate Power Clean (the
(including
indicator lights up).
cutlery rack)
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
TABLET SETTING
DELAYED START
This setting allows to
BUTTON
optimize the cycle
Push the button
performances according
(repeatedly) to delay the
the type of detergent
start of the program.
used. Push the Tablet
Adjustable from 1 to 24
button for 3 seconds (until
hours. With each press of
the indicator lights up) if
the button, the delayed
you are using the
start indicator increases
combined detergents in
by one hour and after 24
tablet (rinse aid, salt and
restarts from 0. Then
deteregent in 1 dose). If
press the START button.
you are using powder
The dishwasher will start
detergent or liquid
after the set time.
detergent, the Tablet
indicator on the control
panel has to be off.
RINSE AID INDICATOR
When lit (at the end of the
ADG 9960
cycle), the rinse aid
5019 396 03522
dispenser needs to be
refilled.
START/RESUME
CANCEL/OFF
BUTTON
BUTTON
Push this button to start
Push this button to switch
the selected program: the
off the control panel.
indicator lights up and
If pressed when a
goes off at the end of the
program is running it
program.
cancels the program
When the door is opened
ongoing draining water for
during a washing cycle, the
1 minute (0:01 is shown
cycle is temporarily
into the display).
paused: the Start indicator
If pressed when the
blinks.
dishwasher is switched
To resume the cycle push
off, it drains any possible
Start button and close the
liquids from dishwasher
door within 3 seconds.
(1 minute process).
Chart
GB -1-
Advertisement
Table of Contents
Related Manuals for Whirlpool ADG 9960
Summary of Contents for Whirlpool ADG 9960
- Page 1 Indicated the cycle duration and the remaining time (h:min). With When lit (at the end of the When lit (at the end of the ADG 9960 A LED light projected “Delayed start” selected it indicates the time remaining until program...
- Page 2 Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system. 2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. GB -2-...
-
Page 3: First Time Use
First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set - Press and hold together Programs and CANCEL/Off buttons for minimum 3 seconds. only before the first wash or if - The current water hardness setting will be visible on the display. -
Page 4: Daily Use
Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator Visual The rinse aid dosage can be adjusted to the detergent indicator used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). -
Page 5: How To Load The Racks
How to load the racks Cutlery rack Position 1 Position 2 A - Two trays to load cutlery Load cutlery with the handle into the pins. Knives or cutlery with bulky handle can be This positions is ideal to load both cutlery, loaded with the head into the pins. -
Page 6: Upper Rack
How to load the racks Upper rack In the upper rack you can load glasses, cups, bowls and, in the right Adjustable glass holder - B (provided in some models) side of the rack, you can load the dessert dishes. helps to load stemmed glasses. - Page 7 How to load the racks Lower rack In the lower rack plates and pots can be loaded. Vertical plate holders When the “Half load/Multizone” is selected the cutlery basket - F (E) can be folded down to create more space to load pots. (provided in some models) can be placed in the lower rack.
-
Page 8: Select Program
Select program Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. - Page 9 What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. How the faults are shown on the display: Function number “F”x - blinking Error number “E”y - blinking...
- Page 10 What to do if... Crockery and cutlery... Possible causes... Solutions..are not perfectly clean/have - T oo little space between dishes (incorrect - Arrange crockery so that items do not touch each other. Concave items (e.g. food residues arrangement of the concave items in the rack). bowls, cups) must be arranged facing downwards in the rack.
- Page 11 What to do if... Crockery and cutlery... Possible causes... Solutions..have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening.
-
Page 12: Precautions And General Recommendations
Precautions and general recommendations 1. Packing - Before cleaning or carrying out maintenance, disconnect the mains plug and turn The packaging materials are 100% recyclable and marked with the recycling symbol off the water tap; also in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician.