Advertisement
Quick reference guide
ON
BUTTON
OFF
BUTTON
(see at right for options description)
Table of programmes
P
Programmes
1
Aqua Steam 60-70°C
2
Quickwash
3
2)
Eco
4
Intensive
5
Power Clean
1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programmes as a result of the appliance's automatic calibration system.
2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
PROGRAMME SELECTION BUTTON
Press button "P" (repeatedly) until the indicator of the required programme lights
up (see "Table of programmes" below).
START BUTTON
The indicator lights up during operation, flashes when a fault occurs and goes off at
the end of the programme.
START BUTTON RESET FUNCTION
Press this button for at least 2 seconds; the selected programme and options are
cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be
cancelled by RESETTING. Detailed instructions are given in chapter "What to do if...".
Available
Loading instructions
options
Automatic programme
recommended for heavily
soiled crockery with dried-on
or burnt food, for example
pans and saucepans. Thanks to
Delay
steam action, soaking or hand
pre treatment is no longer
needed. In addition sanitation is
ensured due to the high
temperature steam.
Lightly soiled crockery, with no
45°C
Delay
dried-on food. * Use of
tablets not recommended.
Normally soiled crockery.
50°C
Delay
Energy-saving programme.
Recommended programme for
70°C
Delay
heavily soiled crockery, especially
suitable for pots and pans.
Recommended programme for
heavily soiled crockery,
70°C
Delay
especially suitable for pots and
pans. Intensive wash with
additional water jets.
BEFORE USING THE APPLIANCE FOR THE
FIRST TIME CAREFULLY READ THIS QUICK
REFERENCE GUIDE AND THE ASSEMBLY
INSTRUCTIONS! THE GUARANTEE IS NOT
APPLICABLE IF FAULTS ARE CAUSED BY
INCORRECT USE OF THE APPLIANCE.
Options and display description
DELAYED START BUTTON
Press the button (repeatedly) to delay the start of
the programme by 3, 6 or 9 hours. Then press the
START button. The dishwasher will start at the set
time.
Consumption
Deter-
gent
1)
Litres
kWh
Minutes
X
13-20 1.10-2.00
100-150
X *
11.0
0.80
30
X
12.0
1.05
165
X
14.0
1.55
155
X
16.0
1.80
220
RINSE AID INDICATOR
SALT INDICATOR
When lit, the rinse aid
When lit, the salt reservoir
dispenser needs to be refilled.
needs to be refilled.
ADG 9995
5019 396 01849
Chart
GB -1-
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Whirlpool ADG 9995
Summary of Contents for Whirlpool ADG 9995
- Page 1 2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test and other tests, contact the following address: ADG 9995 5019 396 01849 “nk_customer@whirlpool.com”.
-
Page 2: First Time Use
First time use How to set detergent type: powder/gel/tablet (if option is available) In order to always ensure the best cleaning 1. Select 3rd programme 2. Press START button 3a. Check your 3b..and set it on your dishwasher 4. Remember to use salt and rinse 5. -
Page 3: Daily Check
Daily check Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) Visual indicator (depending Add salt Visual indicator Fill the salt on model). Screw on the cap. (never add (depending reservoir with Salt residues around cap detergent!). -
Page 4: Switching On The Appliance
How to load CUTLERY RACK How to load UPPER RACK Position 1 Position 2 (In some models only) B - Adjustable glass holder How to adjust upper rack height (if available) A - Two trays for It could be useful to cutlery lift up upper rack to have more space in... -
Page 5: Select Programme
Select programme Quick, permanent or alternating Overview of programmes The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1). Choose programme according to the attached table of programmes (page 1). Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc. - Page 6 What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 7 What to do if... Crockery and cutlery... Possible causes... Solutions..salt indicator lit - Use tablets for soft water. - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up..have deposits: regeneration salt residue - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water - Water too hard.
-
Page 8: Disconnect The Mains Plug
What to do if... Disconnect the mains plug If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty). Before contacting our After-Sales Service, take note of the following: - the description of the fault, - the appliance type and model, - the service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side:...
Need help?
Do you have a question about the ADG 9995 and is the answer not in the manual?
Questions and answers