Connections 12 - Whirlpool ADG 6556 WH User Instructions

Do not use the dishwasher if it has been
damaged in transit. Consult your local
retailer or our After-Sales Service.
(Refer to the separate installation instructions
booklet)
Water inlet and drain:
• Observe any special regulations issued by
your local Water Board.
• Make sure the inlet and drain hoses are kink-
free and are not crushed.
• If the hose length is not sufficient, please
contact your local dealer or our After-Sales
Service.
• The inlet hose must be securely screwed on
to the water tap to prevent leaks.
• The inlet water temperature varies according to
the model installed: inlet hose marked "25° C
Max": maximum temperature 25° C.
All other models: maximum temperature 60° C.
• When installing the appliance, make sure the
drain water discharges correctly (if necessary,
remove the plug from the sink spigot).
• Fix the drain hose to the spigot with a clamp
to prevent it from coming off during operation.
• For appliances with water-stop system only:
if the water connections are made correctly,
the water-stop system safeguards your home
against damage caused by flooding.
Electrical connection:
• Closely adhere to local Electricity Board
regulations.
•
Voltage information is shown on the rating
plate mounted inside the door on the right
hand side.
• The appliance must be earthed as prescribed
by law.
• Do not use extension leads or multiple
adapters.
• Before carrying out maintenance, disconnect
the mains plug.
• The power cable must only be replaced by a
qualified technician.
• For Austria: if the apparatus is series
connected to a fault current switch, this must
be sensitive to the pulsating current.
12
Downloaded from DishWasher-Manual.com Manuals
CONNECTIONS