Pushing The Machine By Hand; Transporting The Machine - Toro 74542TE Operator's Manual

Grandstand mower with 122cm rear discharge turbo force cutting unit
Table of Contents

Advertisement

Pushing the Machine by
Hand
The bypass valves allow you to push the machine by
hand without the engine running.
Important:
Always push the machine by hand.
Do not tow the machine, because hydraulic
damage may occur.
Important:
Do not start or operate the machine
with the bypass valves open. Damage to system
may occur.
Figure 24

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Ensure that the length of ramp is at least 4
times as long as the height of the trailer or
truck bed to the ground.
g030984
20
(Figure
25).

Advertisement

Table of Contents
loading

Table of Contents