Adjusting The Height-Of-Cut - Toro 74542TE Operator's Manual

Figure 20
Driving Backward
1. Move both motion-control levers to the center,
unlocked position.
2. Slowly pull the motion-control levers rearward
(Figure 21).
Figure 21

Adjusting the Height-of-Cut

The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Note:
Using a height-of-cut under 51 mm (2 inches)
increases the wear on the mower-deck belt. Use a
height-of-cut that is greater than 51 mm (2 inches)
whenever possible.
g273674
g273673
18
Figure 22
g267253