Table of Contents
Advertisement
Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the motion-control levers.
1.
Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Push the motion-control levers down out of the
N
-
position
EUTRAL
LOCK
4.
Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure
82).
Figure 82
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
Note:
To adjust the right motion-control lever
horizontally, adjust the cam.
5.
Release the cushion from the rear of the
machine.
6.
Loosen the nut holding the cam
(Figure
82).
g009436
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure
83).
1. Cam
7.
Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the
cam.
Note:
Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises
the handle.
Important:
Ensure that the flat portion of the
cam does not go above a vertical position
(right or left); otherwise you may damage the
switch.
8.
Repeat steps
motion-control lever.
48
Figure 83
2. Nut
3
through
7
for the left
g031538
Advertisement
Table of Contents
