Troubleshooting Tips - Haier QFD15 Series Owner's Manual & Installation Instructions

TROUBLESHOOTING TIPS

Problem
Dryer shakes or Some shaking/noise is normal.
makes noise Dryer may be sitting unevenly.
Clothes take too Improper or obstructed
long to dry ducting
Improper sorting
Large loads of heavy fabrics
(like beach towels)
Controls improperly set
Lint filter is full
Blown fuses or tripped circuit
breaker
Overloading/combining loads
Underloading
The Dry dryness Load consists of a mixture of
level was chosen heavy and light fabrics
but load is still
Lint filter is blocked
damp
Dry Sensor is dirty
Control buttons Controls accidentally put in
not responding service mode
Controls accidentally put in
lock mode
Controls performed an
incorrect operation
Dryer doesn't Control panel is "asleep"
start
Dryer is unplugged
Fuse is blown/circuit breaker is
tripped
Dryer was accidentally paused
when starting Delay Dry
No numbers Dryer is continuously
displayed during monitoring the amount of
cycle, only lights moisture in the clothes
28
Possible Cause
Move dryer to an even floor space, or adjust leveling legs as necessary
until even.
Check the Installation Instructions to make sure the dryer venting is
correct.
Make sure ducting is clean, free of kinks and unobstructed.
Check to see if outside wall damper operates easily.
Separate heavy items from lightweight items (generally, a well-sorted
washer load is a well-sorted dryer load).
Large, heavy fabrics contain more moisture and take longer to dry.
Separate large, heavy fabrics into smaller loads to speed drying time.
Match control settings to the load you are drying.
Clean lint filter before every load.
Replace fuses or reset circuit breakers. Since most dryers use 2 fuses/
breakers, make sure both are operating.
Do not put more than one washer load in the dryer at a time.
If you are drying only one or two items, add a few items to ensure proper
tumbling.
When combining heavy and light fabrics in a load, choose More Dry.
Inspect and clean lint filter.
Clean the sensor with a moist cloth.
Press Start/Pause.
Hold the Lock Control button for 3 seconds to unlock the dryer.
Reset the in-house breaker.
This is normal. Press Power to activate the control panel.
Make sure the dryer plug is pushed completely into the outlet.
Check the building's fuse/circuit breaker box and replace fuse or reset
breaker. NOTE: Electric dryers use two fuses or breakers.
If the light on the Start/Pause button is flashing, the dryer is paused.
Press Start/Pause to restart the countdown.
This is normal. When the dryer senses a low level of moisture in the load,
the dryer will display the dry time remaining.
What To Do
49-3000195