Fisher & Paykel 11 Series Installation Manual page 9

CONNECT CABLES AND HOSES
1. Refer to the Planning Guide
for full service information.
Supply: 220 - 240V, 50Hz
Service: 10A
Outlet: 3-prong grounding-type
Supply: Hoses provided
Pressure: 50KPa (7psi) - 1MPa
(150psi). Min 6 litres/min.
fisherpaykel.com/specify
2. Connect the angled end of
cold hose to the cold water
inlet on the washer.
3. Connect angled end of hot
water hose to the orange outlet
on the washer. If hot hose is
not required, install a blanking
cap.
9