Wansview B4 - 2K Security Camera Outdoor with Non-Stop Solar Power Manual

Table of Contents

Product Diagram

Light Status	Camera Status
Red light on	Power On
Flashing red & blue lights	Camera is ready to connect
Blue light flashing	Camera is connecting WiFi
Blue light solid	Succeed to connect WiFi
Red light flashing quickly	Reset Camera to factory setting Camera is upgrading firmware

warning Warm note: Please make sure your router is connected to Internet.

Download and Install
Go to the App Store or Google Play to search and download the "Wansview Cloud" APP on your smartphone.

Or scan below QR code to get the APP.
Register Account
Open the "Wansview Cloud" APP and register an account with your email and activate it. Tips; Your password must be 8-16 characters, and contains at least the following three categories: numbers, uppercase letters, lowercase letters, or special characters.
Add 34 Camera
1. "Click "Add device" or +"
2. Select the B4 camera
3. Press the power button to turn it on
4. Press the Reset button for 3s to enter pairing mode
5. WiFi setup (Connect to 2.4Ghz WiFi)
6. Scan the QR code
7. Pair succeeds
8. The camera is online
9. Live Video

information Tips:

This Battery camera only works with 2.4GHz Wi-Fi, 5GHz Wi-Fi is not supported!
Please put the camera near to the router during setting up the camera, after connection succeeds, you can place the camera in another place.

warning Note: Put the camera close to the router (2 feet) during setting up the camera.

7/24 Monitoring
With built-in IR-Cut filter and infrared lights, you can view clear camera irnage under day/night mode, 24 hours monitoring with a peace of mind,
Two-Way Audio
With the built-in microphone and speaker, you can communicate not only with the mailman but also with your family at any time, without having to face each other.
Motion Detection
With Built-in PIR sensor, it supports to capture moving objects and automatically trigger IOS short alarm recording and real-time push notifications, TO reduce false alarms and improve accuracy, you can apply the sensitivity level to low for trigger the PIR algorithm.
Smart Power-Saving
We do the intelligent power-saving treatment on hardware and software. Support auto hibernation. When someone enters into the PIR detecting Range, the camera will wake up automatically.
TF Card Storage
Insert a TF card (max 128GBnot included), you can record alarm video to the TF card without using cloud storage. If the camera is working with built-in batteries only, it can record up to 60 seconds of motion video. If the camera is connected with the external power supply like power cable or solar panel, the camera will record the motion video until the motion stops.
Cloud Storage
After enabling cloud storage, alarm records could be automatically saved on the cloud server without data loss or corruption.

The camera can not connect to Wi-Fi?

Please press the reset button on the camera for 10 seconds until the red light flashes quickly and the camera plays the prompt sound of "DIDI", It means the camera has been reset successfully.
Then press the reset button again for 5s until the camera will flash red and blue alternately and play a sound of"Di", now the camera is entering the pairing mode, you can reconnect the camera once again,
Note: After resetting, Please switch your phone network to 2€4Chz WiFi to configure the camera.

Share the camera to another account.

The invited member should download the Wansview Cloud app, and register a new account first
The main account should open the Wansview cloud app, tap "Settings-invite family members" --press < --choose Country and then enter the invited member's account.
The invited member needs to open the Wansview cloud app and then click "'Receive".lf he/she doesn't receive the invitation, please close the app and then open it again.