Deep Cuts; Toggle "On/Off' Switch; Soft Start Feature - Craftsman 320.17541 Operator's Manual

Deep Cuts
The proper cutting depth, (for each pass), is always determined by the material,
the cutter bit size and type, and the power of the motor.
Always make several progressively deeper cuts by starting at one depth and then make
several passes, each time increasing the cutting depth until your desired depth is reached.
Making a cut that is too deep will stress the motor and the cutter bit, and it may burn the
workpiece and du!l the cutter biL It could also "grab" too much of the workpiece and
cause you to lose control of the router, causing a serious accident.
To be certain that your depth settings are as desired, always make test cuts in scrap
material similar to your workpiece before beginning your final cutting.
Remember, knowing the right depth for each cut comes with routing experience.
TOGGLE "ON/OFF" SWITCH (Fig. 7)
Your router motor is turned "ON" and "OFF" by the toggle switch located
on the top cap of the motor housing.
The left side of the toggle switch hood (as you face it) is marked "1" for "On" and
the right side (as you face it) is marked "O" for "Off".
TO TURN THE MOTOR "ON", Push the toggle switch to the left side marked "1",or "On"
TO TURN THE MOTOR "OFF" Push the toggle switch to the right side marked "O", or "Off"_
Always hold the router and cutter bit away from
the workpiece when turning the toggle switch
"On". Only contact the workpiece with the
router and cutter bit after the router has reached
full speed. ONLY remove the router and cutter
bit from the workpiece AFTER turning the router
motor "OFF", and the cutter bit comes to a
complete stop.
Operating in this manner will increase toggle
switch and motor life, and will increase
the quality of your work_
Fig. 7
SOFT START FEATURE
The soft start feature minimizes torque twist, customary in larger router motors,
by limiting the speed at which the motor starts. This increases the motor's life.
20