Craftsman 315.26921 Operator's Manual page 9

Router double insulated
Table of Contents

Advertisement

_
WARNING:Yourrouter s houUd n ever b e
connected topower suppUy whenyouare
assembfing p arts, m aking adjustments, installing
or removing cutters, c baning,or whennotin
use.Disconnecting routerwHU p revent a ccidentaU
starting thatcouUd c auseserious personaU injury.
INSTALUNG/RE_OVmNG CUTTERS
See Figure 2.
[] Unplug your router.
,_
WARNING:
Failure to unplug your router could
result in accidental starting causing serious
[] Depress spindle lock.
,_
WARNING:
To prevent damage to the spindle
or spindle lock, always allow motor to come to a
complete stop before engaging spindle lock.
CUTTER
WRENCH
COLLET
NUT
TO LOOSEN
COLLETNUT
TOTIGHTEN
COLLETNUT
DEPRESS
SPINDLELOCK
Fig. 2
[] Lay router down on table to gain easy access to
collet nut.
[] Place wrench provided onto collet nut and turn
couterclockwise
to loosen.
_l
WARNING:
Rfyou are changing a cutter
immediately after use, be careful not to touch the
cutter or collet with your hands or fingers. They
will get burned because of the heat buildup from
cutting. Always use the wrench provided.
[]
To install cutter: Insert shank of cutter into collet.
The shank of the cutter should be close to but not
touching bottom of collet.
[]
To remove cutter: Remove cutter from collet.
NOTE: The 1/2 in. collet is machined to precision
tolerances to fit cutters with 1/2 in. diameter
shanks. The 1/4 in. collet is machined to precision
tolerances to fit cutters with 1/4 in. diameter
shanks.
[] Tighten the collet nut securely by turning clockwise
with wrench provided.
[] Release spindle lock.
,_.
WARNING:
Do not use cutters with undersized
shanks. Undersized shanks wiii not tighten
properly and could be thrown from tool causing
injury.
1/4in. COLLET
ASSEMBLY
CUTTERWiTH1/4 in.
SHANK DIAMETER
1/2 in. COLLET
ASSEMBLY
CUTTERWiTH1/2 in.
SHANK DIAMETER

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

315.269210

Table of Contents