Craftsman 315.26921 Operator's Manual page 11

ADJUSTING DEPTH OF CUT (WroTH ROUTER
See Figure 7.
The indicator point on the base can be used when
using your router mounted to a router tame,
[] Set the cutter at zero depth of cut,
[] Rotate depth indicator ring to desired depth of cut
on the scab, Refer to "ADJUSTING DEPTH OF
CUT" earlier in this manual
[] Tighten Hocking arm secureiy,
FOR ROUTER TABLE USE ONLY
The speed selecfion chart shown gives suggested
speed settings based on the diameter of the cutter
and the type of materiai being routed,
We suggest that you practice with the variabie speed
feature of your router before instaiHng a cutter and
making cuts in wood,
SPEED SELECTION CHART
CUTTER SIZE
MATERIAL 1/4 3/8 1/2 3/4
INDICATOR
POINT
DEPTH
ADJUSTMENTRING
Fig, 7
ADJUSTING SPEED
See Figure 8.
Your router has a variabHe speed eontroH seHector
designed to aHHow operator controH of speed and
torque iimits. You can make speed selections best
suited to the type of cut, the materiai being cut, and
the size of bit being used. The variabie speed controi
selector allows you to adjust router speed from 15,000
to 25,000 RPM. There is a six-step scab (A to F) on
the variabHe speed controH seHector. To increase the
speed and torque of your router, turn the variable
speed control selector to a higher setting (F). Turn to
a lower setting to decrease speed and torque.
NOTE: If you do not want to use the variable speed
control selector, turn it to the highest possible setting,
and the feature will not be active.
Fig. 8
iNSTALLiNG THE VACUUM ATTACHMENT
[] Place the vacuum attachment in the area at the
rear of the router under the Hocking arm.
[] Secure the vacuum attachment with the two
screws provided.
11