Using The Sb-R200 - Nikon R1 Instruction Manual

2

Using the SB-R200

O
N /
O F
F
 Attaching the SB-R200 to the front of the lens
• The SB-R200 can be attached to the front of the lens using the Attachment Ring SX-1
(p. 31).
1
Slide open the battery chamber lid
in the direction of the arrow.
2
Install the battery, then close the
battery chamber lid by sliding it into
place.
Use CR123A (3V) lithium batteries.
O
N /
O F
F
Replacing the battery
When the SB-R200's battery power is
weak, the green ready-light blinks after the
power has been turned on or after the flash
has fired
• Replace the battery.
3
Slide the SB-R200's Mounting Foot
into the Speedlight Stand AS-20's
Speedlight Mounting Shoe and
slide the lock switch.
The Mounting Foot cannot be inserted in
reverse.
• Slide the lock switch until it stops and make
sure that the red part can no longer be seen.
61