4. Tighten the locknut to the specified
torque. NOTICE: Always tighten the
locknut against the adjusting nut, and
then tighten it to the specified torque.
[ECB00082]
Tightening torque:
Locknut:
41 N·m (4.1 kgf·m, 30 lb·ft)
5
Crossover setting
The crossover setting adjusts the timing when
the shock absorber transitions from the soft
spring to the hard spring.
TIP
It is recommended to adjust the crossover
setting a similar distance whenever the
spring preload is adjusted.
The crossover setting is measured from the
bottom of the spring retainer to the top of
the crossover locknut.
1. Distance B
2. Spring retainer
3. Crossover locknut
4. Crossover adjusting nut
1. Loosen the crossover locknut as shown.
5-43
2
1
3
4