Yamaha YXF10WRAN Owner's Manual page 131

TIP
Make sure that the O-ring is properly seated.
1. O-ring
6. Install the new oil filter cartridge with an
oil filter wrench, and then tighten it to the
specified torque with a torque wrench.
Tightening torque:
Oil filter cartridge:
17 N·m (1.7 kgf·m, 13 lb·ft)
1
1. Torque wrench
7. Install the drain bolts, and then add the
TIP
Refer to steps 11–21 of the "To change the
engine oil" section for the oil filling procedure.
8. Install the right rear panel bolts and quick
9-17
1
specified amount of the recommended
engine oil. Check the engine oil level and
the vehicle for oil leakage. Install the rear
cup holder panel.
fastener screw, and then tighten the bolts
to the specified torque.
9