Yamaha WOLVERINE RMAX4 Owner's Manual page 127

1 1 1
1. Engine oil tank filler cap
2. O-ring
3. Engine oil dipstick
4. Maximum level mark
5. Tip of the engine oil dipstick
6. If the oil level is not between the tip of the
dipstick and the maximum level mark,
add sufficient oil of the recommended
type to raise it to the correct level.
7. Check the O-ring for damage, and re-
place it if necessary.
8. Install the engine oil tank filler cap.
9. Place the rear cup holder panel in the
original position, and then install the
2
quick fastener screws.
3
4
5
To change the engine oil
1. Park the vehicle on a level surface.
2. Remove the rear cup holder panel.
3. Start the engine, warm it up for several
minutes, and then turn it off.
4. Place an oil pan under the oil tank to col-
lect the used engine oil.
5. Remove the engine oil tank filler cap and
the cylinder head cap.
9-13
9