Yamaha WOLVERINE RMAX4 Owner's Manual page 126

To check the engine oil level
1. Park the vehicle on a level surface.
2. Remove the rear cup holder panel by re-
moving the quick fastener screws.
2 2
1. Rear cup holder panel
2. Quick fastener screw
9
3. Start the engine and warm it up to a nor-
mal operating temperature (the engine oil
temperature should reach 60 °C [140 °F]),
then let the engine idle for a minimum of
10 seconds before turning the engine off.
2 2
1 1
2 2
9-12
TIP
If the engine is cold, take the vehicle for a
short drive or let it idle for approximately 10
minutes before checking the engine oil level.
4. Remove the engine oil tank filler cap and
wipe the dipstick with a clean rag.
5. Insert the dipstick back into the oil tank
(without screwing it in), and then remove
it again to check the oil level.
TIP
The engine oil level should be between the tip
of the dipstick and the maximum level mark.