MTX CAN-AM X3-17-SW-P Owner's Manual page 7

Step 8 - Tilt the front of the enclosure down and slide it under the forward crossbar as you set it in
place onto the floor of the vehicle tucking the brake line into the pre-molded slot in the bottom of the
enclosure.
Step 9 - Taking the long bar bracket included, align the slotted holes with the threaded insets on
the top rear of the enclosure. The two large holes at either end should slide over the threaded seat
mounting posts.
Step 10 - Loosely install three (3) T-40 Torx screws into the bracket.
7
M T X . C O M