Related Manuals for MTX THUNDER FORM F250X00BK20A-TN
Summary of Contents for MTX THUNDER FORM F250X00BK20A-TN
- Page 1 F250X00BK20A-TN / F250X00C20A-TN FORD F-250 / F-350 SUPER CAB VEHICLE SPECIFIC SUBWOOFER ENCLOSURE OWNER’S MANUAL M T X . C O M...
-
Page 2: We're Here To Help
MTX! WE’RE HERE TO HELP We’re here to help with any installation or technical support. Visit mtx.com to chat, call 1-800-225-5689 to speak with an MTX Technical Support representative, or visit youtube.com/user/MTXAudioUSA to view product videos. -
Page 3: Specifications
FEATURES • Includes two MTX 10" Terminator Subwoofers • Integrated Amplifier Easily Connects to Existing Systems • Rotationally Molded Design, Finished in Black or Charcoal • Mounts Under Rear Bench Seat with No Loss of Leg Room • EBC and Wiring Harness Included SPECIFICATIONS •... -
Page 4: Installation
INSTALLATION Step 1 - Slide front seats to full forward position and fold up rear seats. This will give you more room to work with. Step 2 - Remove jack tools from floor and set them aside (you will reinstall them later in Step 23). The jack does not need to be removed and stays in factory location. - Page 5 Step 11 - Cut 10ga red power wire to length, connect the supplied fuse holder from the wire kit to the end of the wire. Step 12 - Remove 20 amp fuse from MTX fuse holder. Connect furnished ring terminal to positive side ⁄...
- Page 6 Although, MTX has made every effort to assure proper wiring colors, MTX is not responsible for any changes made by the vehicle manufacturer which sometime occur. If wiring colors do not match then physical verification is required.
- Page 7 Step 16 - Plug power wire harness into amplifier pre-amp. Step 17 - Replace 20 amp fuse under hood. Step 18 - When amp turns on, LED will display red during diagnostic mode, and then green, signaling amp is on and functioning. Amp will only turn on when radio is on. Step 19 - Adjust gain.
- Page 8 Step 20 - Reinstall threshold trim. Locate and align holes in vehicle with pins on trim; and snap back into place. Step 21 - Place the driver side of enclosure in first, so it fits into the seat bracket. Then slide the passenger side, so the enclosure is tight against the seat bottom.
- Page 9 These instructions are guidelines only and in no way are intended to replace a professional installation. As always before screwing or drilling check to make sure you will not damage any wires or hoses or cause damage to the vehicle. Warning: Batteries normally produce explosive gases which can cause personal injury.
- Page 10 NOTES M T X . C O M...
-
Page 11: Warranty Period
WARRANTY PERIOD At MTX Audio we engineer products that will stand up to the test of time. We also realize that from time to time a problem may occur. That’s why our products carry a 2-year limited warranty that begins at the time of sale to the end user. - Page 12 Like, Follow, & Subscribe © 2021 MiTek Corporation. All rights reserved. MTX is a trademark of MiTek Corporation. All other trademarks are property of their respective owners. Designed and Engineered in the U.S.A. Due to continual product development, all specifications are subject to change without notice.