Regulations And Approvals; Personal Safety - Nordson iDry Series Customer Product Manual

2 Nordson iDry® Series Induction Dryers

Regulations and Approvals

Personal Safety

1075452-05
Make sure all equipment is rated and approved for the environment in which it is
used. Any approvals obtained for Nordson equipment will be voided if instructions for
installation, operation, and service are not followed.
Refer to the Declaration of Conformity for approvals standards.

WARNING:
To prevent injury follow these instructions.
• Do not operate or service equipment unless you are qualified.
• Do not operate equipment unless safety guards, doors, or covers are intact and
automatic interlocks are operating properly. Do not bypass or disarm any safety
devices.
• Verify that the ventilation system is operating properly to prevent dangerous
concentrations of volatile particles or vapors.
• Keep clear of moving equipment. Before adjusting or servicing moving equipment,
shut off the power supply and wait until the equipment comes to a complete stop.
Lock out power and secure the equipment to prevent unexpected movement.
• Disconnect, lock out, and tag switches before servicing electrical equipment. Allow 10
minutes for all internal energy storage devices to completely discharge before opening
the enclosure.
• Keep parts of your body and metal implements away from the induction heating zone
while the system is energized. Metal objects will heat up very quickly. Remove all
jewelry, watches, and rings.
• Relieve (bleed off) hydraulic and pneumatic pressure before adjusting or servicing
pressurized systems or components. Disconnect, lock out, and tag switches before
servicing electrical equipment.
• While operating manual spray guns, make sure you are grounded. Wear electrically
conductive gloves or a grounding strap connected to the gun handle or other true earth
ground. Do not wear or carry metallic objects such as jewelry or tools.
• If you receive even a slight electrical shock, shut down all electrical or electrostatic
equipment immediately. Do not restart the equipment until the problem has been
identified and corrected.
• Never disarm any diagnostic or interlock devices including but not limited to:
• Current sensor
• Overtemperature switches
• Air pressure switch
• Coil tray lid safety switches
Disarming these devices will void the warranty and may cause personal harm or
equipment failure.
© 2023 Nordson Corporation