Advertisement
Control panel
Choosing a programme
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean and
in place and the water container is empty and in place
(see Maintenance).
4. Load the machine and make sure items are not in
the way of the door seal. Close the door.
5. If none of the lights are on: Press the ON/OFF
button
6. Choose a programme by checking the Programmes
Guide (see Programmes) as well as the indications for
each type of fabric (see Laundry).
- Select a programme by rotating the PROGRAMMES
knob.
7. Set a delay time and other options if necessary.
8. The START/PAUSE light is flashing green:
- press the START/PAUSE
green light stops flashing.
During the drying programme, you can check on your
laundry and take out items that are dry while others
continue drying. When you close the door again, press
the START/PAUSE button in order to resume drying.
(When the door is opened the START/PAUSE light will
flash Amber, after the door is closed and the START/
PAUSE
button pressed, the START/PAUSE light
PROGRAMME
Indicator
Knob
ON/OFF
Button
button to begin. The
Clean Filter Light
Progress or Delay
Lights
OPTION
Buttons & Lights
will stop flashing and show green.)
Note: During the Post Care phase this light flashes
Amber.
9. At the end of the drying cycle the End light come on
and either :
- The buzzer will beep 3 times to let you know that
your programme is complete.
or - If you have selected the Crease Care option and
you do not take the items out immediately, the items
will tumble occasionally for 10 hours or until you open
the door, the buzzer will then beep 3 times to confirm
the programme is completed.
10. Open the door, take the laundry out, clean the filter
and replace it. Empty the water container and replace
it (see Maintenance).
11. Unplug the dryer.
Empty Water Light
Clean Condenser
Light
START/PAUSE
Button & Light
7
GB
Advertisement
