Hotpoint TCHL 73 Operating Instructions

Hotpoint TCHL 73 Operating Instructions

Hide thumbs Also See for TCHL 73:

Advertisement

Quick Links

Operating Instructions - Tumble Dryer Hotpoint TCHL 73
Control Panel

Choosing a programme

1. Sort your laundry according to fabric type (see Laundry).
2. Open the door and make sure the filter is clean and in place and the water container is empty and in place.
3. Load the machine and make sure items are not in the way of the door seal. Close the door.
4. If none of the lights are on: Press the On/Off button
.
5. Choose a programme by checking the Programmes Guide as well as the indications for each type of fabric.
6. Select a programme by rotating the Programmes knob.
7. Set a delay time and other options if necessary.
8. The Start/Pause light is flashing green: Press the Start/Pause
button to begin. The green light stops flashing.
During the drying programme, you can check on your laundry and take out items that are dry while others continue
drying. When you close the door again, press the Start/Pause button in order to resume drying. (When the door is
opened the Start/Pause light will flash amber, after the door is closed and the Start/Pause
button pressed, the
Start/Pause light will stop flashing and show green).
Note: During the Post Care phase this light flashes Amber.
9. At the end of the drying cycle the End light comes on and either:
- The buzzer will beep 3 times to let you know that your programme is complete.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TCHL 73 and is the answer not in the manual?

Questions and answers

Summary of Contents for Hotpoint TCHL 73

  • Page 1 Operating Instructions - Tumble Dryer Hotpoint TCHL 73 Control Panel Choosing a programme 1. Sort your laundry according to fabric type (see Laundry). 2. Open the door and make sure the filter is clean and in place and the water container is empty and in place.
  • Page 2 - Or, if you have selected the Crease Care option and you do not take the items out immediately, the items will tumble occasionally for 10 hours or until you open the door, the buzzer will then beep 3 times to confirm the programme is completed.
  • Page 3 High Heat Available for Timed Drying Programmes. Press this button and a high heat setting is selected and the light next to the button comes on. Timed programmes have a default of low heat, if the light alongside the button is on then pressing the button selects a low heat setting and the light goes out.
  • Page 4 Sorting laundry - Check the symbols on the care labels of the various garments to verify whether the garments can safely be tumble dried. - Sort laundry according to the type of fabric. - Empty all pockets and check for loose buttons. - Close zips and hooks and fasten belts and strings without tightening them.
  • Page 5 Always check the care labels, especially when placing garments in the tumble dryer for the first time. Below are the most commonly used symbols: Drying times Drying times are approximate and may vary depending on the following: • Amount of water retained by items after the spin cycle: towels and delicate items retain a lot of water. •...

Table of Contents