Control Panel - Hotpoint TCEL 87B Experience Instruction Booklet

Control panel

GB
The ON/OFF button
button is pressed and held for more that 3 seconds the
dryer is turned off, the programme is then cancelled.
Press and hold for more than 3 seconds and the dryer
reactivates.
The PROGRAMME selection buttons set the programme:
press the button corresponding to the programme you
want to select (see Start and Programmes).
The OPTION buttons/lights select available options for
your selected programme. The lights indicate that the
option has been selected (see Start and Programmes).
The START/PAUSE button/light
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. When a programme is running, pressing this
button in pauses the programme and stops the dryer. The
light is green when programme is running, flashing amber
if the programme has been paused or flashing green if
on standby waiting to start a programme (see Start and
Programmes).
Note: This light also flashes amber during the Post Care
phase of a programme.
8
PROGRAMMES
Knob
: If the dryer is running and this
starts a selected
DRYING LEVELS
Knob
Indicator
ON/OFF
Button
OPTION
Buttons & Lights
The Progress or Delay lights show you the status
of the programme, or the delay time when they flash.
During a delayed start the lights flash to show the delay
selected. When (not flashing) they show each stage of the
programme by the corresponding light turning on (see Start
and Programmes).
The Empty Water indicator light signals that the water
container should be emptied. The light will take a few
seconds to go out after replacing the empty water
container, the dryer must be running for this to happen (see
The Controls).
Note: If the water bottle fills the indicator light flashes, the
heat is turned off and your clothes will not dry.
The Clean Filter light gives you a reminder before every
programme that it is essential to clean the filter every time
the dryer is used (see Maintenance and Care).
The Clean Condenser light gives you a reminder that it is
essential to clean the condenser at regular intervals (see
Maintenance and Care).
Clean Filter
Light
TIMER
Empty Water
DRYING
Light
Knob
Progress or Delay
START/PAUSE
Lights Button & Light
Clean Condenser
Light