Cleaning the filter after each cycle Empty the water container after each cycle Cleaning the condenser unit Check the drum after each cycle TCHL 73 Cleaning the dryer FETC70B Dryer description, 7 CDN7000B To open the door The features Control panel...
Installation Where to put your dryer Electrical connections Place your dryer at a distance from gas Make sure of the following before you ● ranges, stoves, heaters, or cook tops insert the plug into the the electrical socket: because flames can damage the Make sure your hands are dry.
Warnings ! The appliance has been designed and Check to see if the dryer is empty before ● built according to international safety loading it. standards. The back of the dryer could ● These warnings are given for safety become very hot. Never touch it reasons and must be followed carefully.
Warnings To minimise the risk of fire in your or explosive substances. Highly flammable tumble dryer, the following should be substances commonly used in domestic observed: environments including cooking oil, Tumble dry items only if they have been acetone, denatured alcohol, kerosene, ●...
Maintenance and Care Switching off the electricity ! Failure to empty the water container may cause the following: ! Unplug your dryer when not using it, - The dryer will stop heating (so the load may still when cleaning it and during all be damp at the end of the drying cycle).
Maintenance and Care Water container Filter Rear Front Condenser unit Air intake Condenser cover Condenser unit Catches Handle Check the drum after each cycle Quick Tips Remember to clean the door filter and Turn the drum manually in order to remove small items ●...
Dryer Description To open the door The features Water container Rating plate Press and release the front panel in position shown Model & Serial numbers Air intake grille Condenser Unit Condenser cover (cover open) Condenser cover handle Filter (Pull to open) Control panel Clean Filter Clean...
Start and Programmes The Controls Post Care When selected, the clothes are occasionally tumbled PROGRAMMES knob ● after the end of the drying and cool tumble cycles, to ! Warning, if after pressing the Start/Pause button help prevent creases developing should you not be , the programmes knob position has changed, the available to remove the load immediately the programme new position will NOT change the programme selected.
Page 9
Start and Programmes Programmes ! If none of the lights are lit; Press the ON/OFF button and then select programme. Programme What it does... How to set it... Note: Dries your clothes on High Heat 1. Position the PROGRAMMES knob Options available: setting, ready for wearing.
Laundry Sorting your laundry Drying times Check symbols on clothing labels to make sure The table (see below) presents APPROXIMATE drying ● that the articles can be tumble dried. times in Minutes. Weights refer to dry garments. Sort laundry by fabric type. ●...
Troubleshooting One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: Possible causes / Solution: The tumble dryer won’t start. The plug is not plugged into the socket, or not making contact. ●...
- in the United Kingdom: 03448 111 606 standard local rate applies - in the Republic of Ireland: 0818 313 413 local Irish rate applies For parts and accessories visit : parts.hotpoint.co.uk/shop Please remember to register your appliance at : www.hotpointservice.co.uk to activate your 10 year parts guarantee.
Product Data... (EU Regulation 392/2012) Brand Hotpoint Models TCHL 73 FETC70B CDN7000B Rated capacity of Cotton laundry for the standard programme at full load 7 kg Energy efficiency class B The weighted Annual Energy Consumption (AE ) 503.8 kWh Consumption per year, based on 160 drying cycles of the standard cotton programme at full and partial load, and the consumption of the low-power modes.
Need help?
Do you have a question about the FETC70B and is the answer not in the manual?
Questions and answers