Depth Stop; Fitting/Removing A Tool; Quick-Release Chuck For Round Shaft Drill Bits; Use - Parkside PBH 1050 C3 Translation Of The Original Instructions

♦ The locking positions on the additional
handle must now be pushed over the locking
pin on the spindle of the appliance .
♦ Turn the additional handle
to tighten it .
NOTE
► Move the additional handle
various locking positions depending on
your working position . Undo and lock the ad-
ditional handle

Depth stop

♦ Push the locking button for the depth stop
and keep it pushed in .
♦ Insert the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards .
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth .
♦ Release the locking button for the depth stop
to lock the depth stop

Fitting/removing a tool

WARNING!
► Switch the appliance off and remove the
power plug before starting any work on the
appliance .
Fitting a tool
♦ Before fitting a tool into the tool holder
grease it lightly .
♦ To insert, pull the locking collar
and insert the tool .
♦ Release the locking collar
tool holder . Check that the tool is properly
locked by pulling it . The system has radial play
because of the design .
Removing a tool
♦ To remove the tool, pull the locking collar
backwards .
■ 6 │ GB │ IE │ NI │ CY
clockwise again
into the
as described previously .
into the additional
out until the distance
.
,
backwards
. This locks the
Quick-release chuck for round shaft
drill bits
WARNING!
Do not use the quick-release chuck
►
for hammer drilling or chiselling!
♦ Set the function selector switch
symbol .
Inserting the quick-release chuck for round
shaft drill bits
♦ To insert the quick-release chuck
fig . A) pull the locking collar
Insert the quick-release chuck
♦ Release the locking collar
tool holder . Check that the tool is properly
locked by pulling it .
Removing the quick-release chuck for round
shaft drill bits
♦ To remove the quick-release chuck
locking collar backwards and remove the
quick-release chuck

Use

Select operating mode

Function selector
♦ Press and hold the release button
function selector switch
selector switch so that the required symbol
engages at the arrow mark:
Function
Drilling
Hammer drilling
Chiselling
Chisel position adjustment
to the drill
(see also
backwards .
.
. This locks the
, pull the
.
on the
. Turn the function
Symbol
PBH 1050 C3