Table of Contents
Advertisement
( 1 ) Example: To change the Pr. 79 "operation mode selection" setting
from "2" (external operation mode) to "1" (PU operation
mode)
(For details of Pr. 79, refer to page 110.)
Press the
key, to choose the
MODE
parameter setting mode.
"Parameter setting mode
PU
MODE
SET
REV
STOP
FWD
RESET
MODE
To 3.2.6 Operation mode
"Current setting
SET
Flicker
Most significant
digit flickers
SET
"Setting change
Press for
1.5s
SET
"Setting write
When
1) If the RUN indication is lit or flickering,
2) You cannot set any value that is outside the
"1" (PU operation mode) has been set in Pr. 79.
If the value and
for 1.5 seconds when writing the value.
Press the
restart the setting from the beginning.
54
Middle digit flickers
SET
×7 times
or
×3 times
0 to 9
appears
stop operation by pressing the
key or turning off the forward rotation
(STF) or reverse rotation (STR) signal
connected to the control terminal.
parameter setting range. Write a value within
the setting range.
appears, you did not press the
key once, press the
Least significant
digit flickers
×9 times
or
×1 times
SET
0 to 9
RUN
STOP
RESET
do not flicker but
key
SET
key, and
SET
Advertisement
Table of Contents
