Table of Contents
Advertisement
Enter the VPI and VCI values, select a DSL Link Type (Internet connection type): EoA (EoA is for PPPoE, IPoE, and
Bridge.), PPPoA or IPoA. Leave other options unchanged from factory defaults and click
and then refer to
To Set up WAN Service for ATM Interface
to configure the WAN service for Internet access.
_________________________________________________________________________________________________
TIP
If you are unsure about the VPI/VCI parameters, see
Appendix 5 VPI/VCI
List. Or if your ISP and the VPI/VCI
information is not covered there, ask your ISP to provide it.
_________________________________________________________________________________________________
To Set Up the ETH Interface
Select ETH Interface and click Add.
24
Advertisement
Table of Contents
